I-PRESS® SUGGESTED MAINTENANCE SCHEDULE
ONLY PERFORMED BY AUTHORIZED MAINTENANCE TEAM LOCK OUT - TAG OUT
MONTHLY
1) Same as daily & weekly.
2) Run slide adjust to upper and lower limits and be sure limit switches prevent over travel as stamped on indicator. DO NOT RUN SLIDE ADJUST MOTOR WHEN DIES ARE COMPRESSED as this will damage the slide adjust system and trap the thermal overload for slide adjust motor.
4) Check all air hoses to clutch & brake and counter balance cylinders.
5) Check upper lubrication and distributor blocks are in no leak condition.
2) Run slide adjust to upper and lower limits and be sure limit switches prevent over travel as stamped on indicator. DO NOT RUN SLIDE ADJUST MOTOR WHEN DIES ARE COMPRESSED as this will damage the slide adjust system and trap the thermal overload for slide adjust motor.
4) Check all air hoses to clutch & brake and counter balance cylinders.
5) Check upper lubrication and distributor blocks are in no leak condition.
EVERY 6 MONTH
1) Check and tighten internal slide bolts.
2) Check and tighten connecting rod bolts.
3) Add oil to connecting rod bolts.
4) Clean out interior of slide.
5) Check slide gib and crank bushing distributor block behind slide and make sure in no leak condition.
2) Check and tighten connecting rod bolts.
3) Add oil to connecting rod bolts.
4) Clean out interior of slide.
5) Check slide gib and crank bushing distributor block behind slide and make sure in no leak condition.
EVERY 12 MONTH
1) Check parallelism of slide to bolster at 90-18-270 degrees.
2) Check slide gibs for clearance and any sign of wear.
3) Jack up of overall stack clearance to be compared to JIS ST class inspection document from when press was new.
4) Check flywheel belt tention.
5) Confirm coder mount is secure.
6) Confirm overrun sensor and mechanical cam in encoder housing is secure.
7) Confirm encoder belt, pullies and keyways are secure.
8) Lubricate flywheel bearing (see lube instr.).
9) Clean press inside and out.
10) Check all bolts and cap screws and make sure everything is secure.
2) Check slide gibs for clearance and any sign of wear.
3) Jack up of overall stack clearance to be compared to JIS ST class inspection document from when press was new.
4) Check flywheel belt tention.
5) Confirm coder mount is secure.
6) Confirm overrun sensor and mechanical cam in encoder housing is secure.
7) Confirm encoder belt, pullies and keyways are secure.
8) Lubricate flywheel bearing (see lube instr.).
9) Clean press inside and out.
10) Check all bolts and cap screws and make sure everything is secure.
IF YOU WOULD LIKE ANNUAL PREVENTATIVE
MAINTENANCE PROGRAMS CALL
SUTHERLAND 310-453-6981
MAINTENANCE PROGRAMS CALL
SUTHERLAND 310-453-6981
